Volvo RTI Guia de Instalação descarregar pdf (Página 5)

Page 5

Installing the Device

Front Mount Installation

WARNING!

THE IGNITION SWITCH MUST BE IN POSITION 0 THE KEY REMOVED BEFORE THE NEGATIVE BATTERY LEAD IS

DISCONNECTED. FAILURE TO DO SO WILL RESULT IN AN AIRBAG WARNING LIGHT. ALWAYS DISCONNECT THE

NEGATIVE LEAD OF THE BATTERY WHEN WORKING ON THE ELECTRICAL SYSTEM OF A VEHICLE.

WHEN THE WORK IS COMPLETE THE KEY MUST BE TURNED TO POSITION II BEFORE RECONNECTING THE NEGATIVE

BATTERY LEAD.

1) Remove the radio from the dash. The procedure for doing this varies by model and year.

Connect one end of the Melbus cable to the back of the radio. Often there are two DIN style

connectors; however the Melbus cable will only connect to one. Route the cable to where the

iMIV/MII is being installed.

2) Remove the power harness from the back of the radio and connect the Y-Harness Power Cable

in between the radio and the stock power harness. Connect the Front Mount Power Cable to the

empty connector of the Y-Harness cable and route it to where the iMIV/MII is being installed.

3) Connect the Melbus cable to the port labeled ‘Melbus’ on the iMIV/MII. Connect the power

cable to the blue connector labeled ‘Power’ on the iMIV/MII.

4) If you have an iMIV device route the iPod cable to where you want to store the iPod. Commonly

this is the center console or glove box. Connect the 13 pin DIN connector the port labeled ‘iPod’

on the iMIV device.

5) It is recommended that the iMIV/MII be secured to the vehicle with 3M DualLock or a similar

product. Ensure everything functions as it should and reinstall the radio and any trim panels that

were removed.

1 2 3 4 5 6 7 8 9 10 ... 18 19

Sem comentários

Volvo RTI Guia de Instalação Página 5