Volvo RTI Guia de Instalação descarregar pdf (Página 7)

Page 7

Melbus Prepped Installation

WARNING!

THE IGNITION SWITCH MUST BE IN POSITION 0 THE KEY REMOVED BEFORE THE NEGATIVE BATTERY LEAD IS

DISCONNECTED. FAILURE TO DO SO WILL RESULT IN AN AIRBAG WARNING LIGHT. ALWAYS DISCONNECT THE

NEGATIVE LEAD OF THE BATTERY WHEN WORKING ON THE ELECTRICAL SYSTEM OF A VEHICLE.

WHEN THE WORK IS COMPLETE THE KEY MUST BE TURNED TO POSITION II BEFORE RECONNECTING THE NEGATIVE

BATTERY LEAD.

1) Connect the factory installed Melbus cable to the iMIV/MII device. Ensure that the other end is

plugged into the radio at the front of the vehicle.

2) Connect the ground lug of the Generic power cable to either a screw on the chassis or the

negative terminal of the battery.

3) Using the included ScotchLock connector attach the red (positive) lead of the Generic Power

Cable to a constant +12v source. This means one that does not ‘turn off’ when the key is

removed from the vehicle. Failure to do this will result in improper operation of the iMIV/MII

device.

4) Connect the blue connector of the Generic Power Cable to the iMIV/MII device.

5) If you have an iMIV device route the iPod cable to where you want to store the iPod. Commonly

this is the center console or glove box. Connect the 13 pin DIN connector the port labeled ‘iPod’

on the iMIV device.

6) It is recommended that the iMIV/MII be secured to the vehicle with 3M DualLock or a similar

product. Ensure everything functions as it should and reinstall the radio and any trim panels that

were removed.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Sem comentários

Volvo RTI Guia de Instalação Página 7